WattPerchMenu

Guides

Is plug-in solar worth it if the power you send back earns nothing?

Only the power your home uses while the panel makes it lowers your bill. We asked our own calculator how much that is for two kit sizes in twelve cities.

Checked on Approved by Predrag Bogicevic on

The short answer

Mostly yes, as long as someone uses power at home during the day.

A 400 W kit’s power is almost all used at home. An 800 W kit in a home that is empty all day sends a large part of its power to the grid, where it earns nothing.

Panel on a balcony railing facing south, no shade. Figures from WattPerch’s calculator, asked on November 21, 2026 for twelve cities.

400 W kit, nobody home

78–84%

of its power is still used at home. With someone home it is 100 %, rounded.

800 W kit, nobody home

41–48%

of its power flows back unpaid.

Saved a year, 400 W, someone home

$54–$125

Lowest in Salt Lake City, UT, highest in Portland, ME.

Saved a year, 800 W, someone home

$94–$211

Lowest in Salt Lake City, UT, highest in Los Angeles, CA.

Why the savings differ so much

Mostly the price of power. The state averages we used run from $0.13 per kWh in Utah to $0.32 in Maine.

Average residential prices, EIA, August 2026.

Why the power you send back matters

A panel makes most of its power in the middle of the day. Your home uses power all day long, but usually in smaller amounts at any one time: the fridge, the router, whatever is switched on. The calculator looks at each hour of the year and counts the power your home uses in that hour as yours. Anything the panel makes beyond that goes out to the grid.

The state laws we have read keep plug-in kits out of net metering, or say nothing about paying for that power. So the calculator counts it at $0. Only the power you use yourself saves money, at the price you pay per kWh.

A 400 W kit rarely makes more than a home uses, so little is lost. An 800 W kit has twice the rated power. Around noon it often makes more than the home uses, and in a home that uses little during the day, much of that extra leaves the house.

Nobody home

The 400 W kit’s power is 78–84 % used at home. For the 800 W kit it is 52–59 %, and it saves $59–$136 a year.

Assumed use from 9:00 to 17:00: 150 W.

Someone is home

The 800 W kit’s power is 84–89 % used at home.

Assumed use from 9:00 to 17:00: 350 W.

Home office

The 800 W kit’s power is 95–99 % used at home.

Assumed use from 9:00 to 17:00: 500 W.

The three presets differ only between 9:00 and 17:00. The rest of the day is the same for all three: 150 W at night, 400 W from 6:00 to 9:00, 600 W from 17:00 to 22:00 and 300 W after that. These are assumptions, the same on every day of the year, and not a measurement of any real home. If your days look different, the calculator lets you pick the preset closest to yours.

Twelve cities: the share of the power used at home

The table scrolls sideways: three columns for each kit.

Share of each kit’s yearly output used at home, by city and daytime use
City400 W kit800 W kit
Nobody homeSomeone is homeHome officeNobody homeSomeone is homeHome office
Los Angeles, CAZIP 9001283 %100 %100 %57 %89 %99 %
Denver, COZIP 8020278 %100 %100 %52 %84 %96 %
Bridgeport, CTZIP 0660483 %100 %100 %58 %89 %97 %
Boston, MAZIP 0210881 %100 %100 %58 %87 %96 %
Baltimore, MDZIP 2120282 %100 %100 %57 %88 %98 %
Portland, MEZIP 0410179 %100 %100 %56 %85 %95 %
Manchester, NHZIP 0310180 %100 %100 %56 %86 %96 %
Newark, NJZIP 0710283 %100 %100 %58 %89 %98 %
New York, NYZIP 1000784 %100 %100 %59 %89 %98 %
Salt Lake City, UTZIP 8411182 %100 %100 %55 %88 %98 %
Virginia Beach, VAZIP 2345683 %100 %100 %59 %89 %98 %
Burlington, VTZIP 0540181 %100 %100 %56 %87 %96 %

Twelve cities: what that saves a year

The table scrolls sideways: the price, then three columns for each kit.

Dollars saved per year by each kit, by city and daytime use, at the state’s average residential price
CityPrice per kWh400 W kit800 W kit
Nobody homeSomeone is homeHome officeNobody homeSomeone is homeHome office
Los Angeles, CA$0.30$100$121$121$136$211$234
Denver, CO$0.17$62$79$79$81$131$148
Bridgeport, CT$0.25$74$90$90$102$156$172
Boston, MA$0.30$94$116$116$131$197$218
Baltimore, MD$0.21$67$81$81$91$140$155
Portland, ME$0.32$99$125$126$136$209$234
Manchester, NH$0.28$86$108$108$118$180$201
Newark, NJ$0.25$74$89$89$102$155$171
New York, NY$0.29$81$97$97$113$171$187
Salt Lake City, UT$0.13$45$54$55$59$94$104
Virginia Beach, VA$0.18$55$66$66$76$115$127
Burlington, VT$0.24$72$89$89$98$151$167

Shares are rounded to whole percent, so a share above 99.5 % shows as 100 %. Price per kWh: each state’s average residential price for August 2026, published by the U.S. Energy Information Administration (EIA). It is one figure for every utility and tariff in the state, not your utility’s rate.

Does that pay for a kit?

That depends on what the kit costs, and this page does not list kit prices. Divide a kit’s price by what it saves a year, and you get the number of years it takes to pay for itself. The calculator does this for your address. Enter your ZIP code, then a kit’s price under “Your own rate and kit prices” in the result. Using your own rate from your bill makes the savings closer to what you pay.

Work out your own numbers

What these figures do not include

A battery, which could hold midday power for the evening. Time-of-use rates, fixed charges and a real year’s weather. Shade, and any direction other than south: the guide on mounting shows what those do to the output.

Whether your state lets you plug in a kit at all, and on what terms: the state pages.

How these figures were made

On November 21, 2026 we asked WattPerch’s own calculator, the same one behind the calculator page, for 36 results: twelve places, each with the three daytime presets. The places are one downtown ZIP code in the largest city of each state whose plug-in solar bill we have read from an official source. That is every jurisdiction on our state pages except the District of Columbia, whose bill we could not read. For Boston we used 02108, a downtown ZIP code, because 02201 has no Census area of its own.

Each result uses the panel’s hour-by-hour output for a typical year from PVWatts, the federal solar-output service, at 90° (vertical on a railing) and 180° (south), with 14 % for wiring and other losses and no shade. We keep the full answers, with every assumption, in our evidence file (named in the sources below). How the numbers are made explains the calculation.

Sources

The sources of this page, what we read in each, and when
SourceWhat we readChecked
WattPerch estimate API36 complete results for twelve ZIP codes and three daytime presets, stored in research/evidence/wattperch/worth-it-2026-11-21.json
NLR PVWatts V8 developer.nlr.govhourly output for a typical year (NSRDB weather data)
U.S. Energy Information Administration (EIA) eia.govaverage retail price of electricity, residential, by state, monthly (Open Data API, electricity/retail-sales)
NLR Utility Rates V3 developer.nlr.govthe name of the utility only (its rates, from 2012, are not used)
US Census Bureau census.govZIP Code Tabulation Areas (2024 Gazetteer, 2020 relationship files)

Predrag Bogićević is responsible for this page and checks it against these sources before it is published. Write to us through the legal notice if something is wrong.